SHARP AR-M550N PCL5E DRIVER DETAILS:
|File Size:||20.4 MB|
|Supported systems:||Windows 2K, Windows XP, Windows Vista, Windows Vista 64 bit, Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit, Windows 10|
|Price:||Free* (*Free Registration Required)|
SHARP AR-M550N PCL5E DRIVER
Information on Printers from Sharp.
Technote troubleshooting Problem Abstract This document contains information on the capabilities that are supported sharp ar-m550n pcl5e printer hardware from Sharp. Cable Power Cable. Cable T-Adapter. Add to Cart. Page of 57 Go. Be sure to become thoroughly familiar with this manual to gain.
Sharp Ar m550n u Ar m620n u Ar m700n u
Before installing this product, be sure to sharp ar-m550n pcl5e the installation. Choose from numbers 2 to 4. Using the numeric keypad, select the number that corresponds to the operation mode.
Using the mumeric keypad, select the number that corresponds to the mode for which to make adjustments. Enter the density correction value using the numeric keypad. Sharp ar-m550n pcl5e two copies one in original table mode and the other in DSPF mode and compare the copies in terms of density. The density level is dynamically changed according to the original's pattern.
AE fix ON: The density of the leading edge of the original is detected and used to determine the overall density exposure level. The overall density level is fixed. Adjust the fusing paper guide position by loosening the fusing sharp ar-m550n pcl5e guide fixing screws and the sliding the fusing paper guide in the arrow direction. The maximum width detection level is recognized.
Set the manual paper feed guide to the width for the A4R size. The A4R width detection level is recognized.
The A5R width detection level is recognized. The minimum width detection level is recognized. Open the paper feed guide to the maximum width position.
Select MIN. Select MAX.
ADJ 15 Adjusting the original size detection in original table mode This adjustment is needed in the following situations:. Gradually turn over the original detection arm unit in the arrow direction, and loosen the original cover switch actuator adjusting screw so that the OCSW indicator changes from inverse video to normal video when the arm unit top reaches a height of 32r0. Then move the actuator to adjust its sharp ar-m550n pcl5e. If the original cover switch turns on in improper timing, the original detection mechanism mail fail to operate correctly.
Open the original cover.
This sets the sensor level with no original detected. This sets the sensor level with an original detected. Press the four cross mark points.Download Sharp AR-MN PCL5e driver for Printers, different software versions available here. Sharp Sharp ar-m550n pcl5e Printer PCL5e Driver for Windows 9x/ME//XP 32bit.